H-100 Control Panel

DESCRIPTION

• Digital controls for all safety shutdowns

• Isochronous governor control built

• Sealed Digital Circuit Board

• 2 Amp static battery charger

• Mates with HTS transfer switch

STANDARD FEATURES

The H-100 Control Panel is a digital microprocessor electronic controller that integrates all engine and transfer switch functions into a single control system.  Two 4 line x 20 displays
Full system status

3 phase sensing voltage regulator

Remote ports

- RS232

- RS485

- Canbus

Water proof connections

All engine sensors are 4-20 ma for minimal interference Built in PLC.  In addition, the generator set parameters can be manipulated and monitored without standing in front of the control panel with GenLink® software. The Generac H-100 control also monitors and controls transfer switch functions when used with the HTS Transfer Switch. 

Monitors utility voltage

Monitors generator voltage

Timer for line interrupt delay

Timer for engine warmup

Timer for minimum engine run time

Timer for return to utility position

Timer for engine cooldown

Built in exerciser timer (7 day)

Additional 2 wire start controls